How to Measure

Get the measurements right and the gate fits first time. The most important thing to know: the sizes on our product pages are the finished size of the gate. We build exactly the size you choose, so the allowance for hinges and clearance comes off your opening before you pick a size.

Width

Measure the full opening in three places: at the top, at the middle and at the bottom. Use the smallest of the three.

Openings are rarely square. Posts lean, walls bow, and ground shifts. The narrowest point is what the gate has to pass through.

Then take off the allowance for hinges, latch and movement:

  • Garden and picket gates: take off 20mm
  • Driveway gates: take off 40mm

Choose the nearest size at or below that figure. For example, a 920mm opening needs a 900mm gate, and a 2440mm driveway opening needs a 2400mm pair.

If you are putting new posts in at the same time, set them so the gap between them is the gate width plus 20mm (or plus 40mm for a driveway pair).

Height

Measure from the ground to where you want the top of the gate to sit, and allow ground clearance underneath — usually 50mm to 75mm so the gate swings freely over uneven ground, more if the ground rises as the gate opens.

Gate heights are measured at the sides. On dome, under dome and swan neck gates the curve rises above that height. The one exception is the Featheredge Dome Top garden gate, which is measured to the top of the dome.

Driveway gates

The width you choose is the total width of the pair, not the size of each gate. A 2400mm pair is two gates of 1200mm each, one left and one right.

Tolerance

All gates are built to within ±10mm of the size ordered.

Posts

Posts are not supplied. We recommend 75 x 75mm or 100 x 100mm posts for garden and picket gates, 100 x 100mm for driveway gates up to 2400mm wide, and 150 x 150mm for driveway gates over 2400mm.

Bespoke sizes and sloping ground

If your opening doesn't suit one of our standard sizes, or the ground rises across the opening or as the gate swings open, use our bespoke enquiry form. For bespoke orders it works the other way round: send us the opening measurements and we work out the gate size and clearances for you.

Still unsure?

Send us your measurements and a photo of the opening and we will check them before anything is cut. We would rather spend ten minutes on this than build you the wrong gate.