Swan Neck Double Driveway Gates — Black Bars
Need a size we don't list? Request a bespoke quote
Pair of gates only. Add hardware below if you need it.
About this gate
A matched pair of swan neck driveway gates with an open bar section. The top rails sweep up in mirrored S-curves from each outer stile, meeting at the highest point in the middle, with slim black bars set beneath them.
Solid tongue and groove boarding across the lower half gives privacy at ground level. The bars above keep a wide pair from reading as a wall across the drive, and let you see who is at the gate before you open it.
The bars are black rigid PVC rather than timber. They hold their colour, never need treating, and will not move with the seasons the way a turned timber bar can. Against a painted or stained gate they read as ironwork. The open bar section is approximately 250mm deep, varying slightly with the curve of the rail.
Supplied as a pair, one left and one right. The width you choose is the total finished width of both gates together — a 2700mm pair is two gates of 1350mm each. Take 40mm off your opening when choosing a size (see How to measure). Height is measured at the outer edges; the curve rises towards the middle.
Specification
Construction
Framed and ledged pair with shaped swan neck top rails and black PVC bar section. Diagonal brace on 1500mm and 1800mm high gates.
Timber
C24 graded, pressure treated, screw-fixed frame
Thickness
47mm
Finish supplied
Natural — not stained or painted, ready to paint or stain
Opening direction
Left and right pair
Height measured
At the outer edges — the curve rises towards the middle
Size tolerance
±10mm on width and height
Recommended posts
100 x 100mm up to 2400mm wide, 150 x 150mm over 2400mm (posts not supplied)
Maximum leaf width
1800mm per leaf
Made in
United Kingdom
Delivery
Free delivery to most of England and Wales. A surcharge applies to Central London, parts of Devon, Cornwall, parts of Wales and Northumberland, Scotland, Northern Ireland and the islands. You'll see it at checkout when you enter your postcode.
Your gate is made to order and takes 10 working days to build, then 3 to 5 working days for delivery.
Our carrier will contact you by email and text to arrange delivery, which is why we ask for a phone number at checkout. Please make sure there is safe access and someone available to receive the delivery.
Prefer to collect? Choose collection at checkout and pick up from our workshop at Unit 3, Southdown Farm, near Swindon (SN7 7UA).
How to measure
Standard sizes
The size you choose is the finished size of the gate. We build exactly what you order.
Measure your opening at the top, the middle and the bottom, and use the smallest of the three. Openings are rarely square.
Take off 20mm for a garden gate, or 40mm for a pair of driveway gates, to leave room for hinges, latch and movement. Then choose the nearest size at or below that. A 920mm opening needs a 900mm gate.
Driveway gate widths are the total for the pair, so a 2400mm pair is two 1200mm gates.
Height is measured at the sides, so on curved tops the curve rises above it. Featheredge dome top gates are the exception: their height is measured to the top of the dome. All gates are built to ±10mm.
Bespoke sizes
If your opening doesn't suit a standard size, request a bespoke quote. Send us the opening measurements and we'll work out the clearances for you.
Returns
Standard size gates can be cancelled within 14 days of delivery under the Consumer Contracts Regulations 2013. You are responsible for the cost of returning the goods; we can arrange collection and deduct the cost from your refund.
Gates made to your own measurements through our bespoke process are exempt from the 14-day right to cancel.
Timber is a natural material. Variation in grain, colour and knot pattern is normal, as is minor seasonal movement, and neither is a defect. Your statutory rights if a gate is faulty or not as described are unaffected.